BURY CC 9048 USER Manual - Manual (Page 14)

13
Note:
If the rechargeable battery of the mobile phone is low, it is sometimes not possible to X
establish a
Bluetooth connection.
The HFCK has a memory for the storage of the identification of up to 8 mobile phones. In case
a ninth mobile phone is connected, the oldest entry in the HFCK memory will be cancelled.
If you wish to cancel a Bluetooth connection, you can either disconnect it conveniently at the HFCK
or at your mobile phone. In addition, the connection is disconnected, if you move too far away from
the vehicle while taking your mobile phone with you and thus leave the reception radius of the HFCK.
Please note that the capacity of your mobile phone’s storage battery can quickly decrease when
the
Bluetooth function is active. If you do not want to use the Bluetooth function anymore,
e.g. if you leave the vehicle for a longer period, it is recommended to deactivate this function.
Thanks to the Multipoint Function you are able to connect two mobile phones at the same time with
the HFCK via
Bluetooth. You operate this function with the middle button. First, activate the Multipoint
function (see operating table) in STAND-BY mode (no coupled telephones). Then, connect and disconnect
the first mobile phone, and then connect and disconnect the second phone. Now, press the function button
and the system connects both telephones. The mobile phone connected most recently is given priority
which means all of the functions described in the table (on page 13 of this guide) refer to this tele-
phone.
Despite the huge number of tested mobile phones, we can not guarantee that all configurations will be
compatible with each other while using multipoint function.
After switching the HFCK on the system will connected with the smartphone that was most recently
connected. The condition for this is that this phone is in the vehicle, the
Bluetooth function is activated
and the interfacing identification to the remote control has not been deleted.
In the case of there being incoming calls on each phone at the same time, then the incoming call on the
second phone can only be received after the first call has been declined. It is also possible to end the first
call and to then decline the second call (both steps are completed by pressing in the minus button), or to
end the first call and to then immediately answer the second call (by pressing in the plus button). Putting
the first phone call on hold is not possible, however, because the same phone number is not being called.
Note:
Please comply with the country-specific laws concerning in-car telephone calls. X
In order to be able to use the voice dialling functions (Voice-Tags) of your mobile phone with X
the HFCK, the phone numbers must have been marked previously on your mobile phone in
a corresponding way.