BURY CC 9048 USER Manual - Manual (Page 9)

8
Installation of the hands-free car kit
Toggling between the installation options 1, 2 and 4 is done with the buttons “+” and “-”. In order to
toggle the installation options, you must keep these buttons pressed simultaneously for 4 seconds.
Option 1 is the standard setting upon delivery of the hands-free car kit. Music and voice are output via
the loudspeakers using the ISO jacks. The amplifiers of the hands-free car kit are used for playback.
Mobile audio is active in the device. In the case of this option the Mobile audio cannot be switched off.
Switching on the Mobile audio and switching off the Mobile audio with use of pushbuttons on the re-
mote control is inaccessible.
Options 2 and 4 feeds music to the radio via the four LINE cables, and voice signals are fed to the
loudspeakers via the ISO jacks. Additionally, after switching on the external audio, mobile audio can
be redirected to the car loudspeakers using ISO jacks.
Option 3 does not concern this device.
Output of voice (telephone) via Output of music via
ISO LINE ISO LINE
Option 1    
Option 2 Mobile audio off
  - 
Mobile audio on
   
Option 3 It does not concern the CC 9048 device
Option 4
refers to the device
with BURY
loudspeaker
Mobile audio off
  - 
Mobile audio on
   
Installation of the hands-free car kit
Step 1:
Pull the ISO jacks at the back of the radio off and replace them with the jacks at the ISO cable harness.
Connect the now free ISO jacks with both sockets from the ISO cable harness (see picture).