Bel Canto Design PRe6 - Manual (Page 10)

the RIGHT and LEFT arrow keys to
select the desired input and then
press ENTER to adjust level. Use the
UP and DOWN arrow keys to adjust
volume level accordingly and press
ENTER again to exit.
Set Soft Mute Offset:
The volume level for Soft Mute is
preset to - 20 dB below the current
volume level. Press ENTER to adjust
the desired input. Use the UP and
DOWN arrow keys to adjust setting
preferences and press ENTER again
to exit.
Set Zone 2 volume:
Located at the bottom most
Configuration Input screen, you will
the find Zone 2 volume settings.
ZONE 2 has been preset to 65.0.
Press ENTER to edit volume level
using the UP and DOWN arrow keys.
Press ENTER again to exit Zone 2
volume level edit mode.
Zone 2 Function
When a 7.1 input is not enabled in
Configuration Inputs, the SB
(Surround Back) outputs (both RCA
and XLR) are used as an additional
volume controlled output for use in a
second zone. If you have an external
volume control for your second zone,
adjust Zone 2 volume level to 84.0
(unity gain) for proper output to Zone
2. Input selection for Zone 2 is
accomplished using the TAPE button
found on both the remote and front
panel. The red LEDs on the back
panel will indicate which source is
selected for TAPE/Zone 2 for output
(XLR and RCA). As you continue to
press the TAPE button, the display
will cycle through the various inputs
that will be routed to the TAPE/Zone
2 output.
page 10 © 2002 bel canto design, Ltd. PRe6 User’s Guide rev082102
Bandwidth Into >600 Ohms: DC-200KHz
Volume setting for unity gain • 84.0
Signal to Noise Ratio @ 2 Volt RMS • >100 dB A weighted, 20Hz-20kHz
Distortion @ 2 Volt RMS/ 1kHz <0.005%
Input overload: 10 V RMS
Output Impedance: 10 Ohms
Input Impedance: 20K Ohms
Gain: 16dB
Maximum Output Level: 10 V RMS
Idle power draw • 21 Watts
Power Requirements • 110-120 VAC 50-60 Hz or 220-240 VAC 50-60 Hz
Dimensions • 17.5” W x 14.5” D x 4.5” H (445 mm x 368 mm x 114 mm)
Weight: 24lbs. (13 kg)
Specifications