Bel Canto Design PRe6 - Manual (Page 7)

TAPE – On both the remote and the
front panel, the TAPE button will
cycle through the inputs, selecting
the input to be routed to the Tape
Out. If 7.1 Surround is not selected in
Configuration Inputs, the two
Surround Back (SB) (both XLR and
RCA) channels will automatically be
configured as Zone 2 and routed
along with the Tape Output selection
(for further explanation on ZONE2,
please see page 10).
NOTE: Tape Out and ZONE2 route
the same input.
When the tape input of a tape deck is
connected to the tape output of the
PRe6, you may record any selected
source (CD, Phono, Tuner, etc) except
the TAPE input. When the tape out-
put of a tape deck is connected to the
TAPE IN of the PRe6 you may moni-
tor your recording.
Standby - When in standby mode the
red LED is engaged and audio output
is hard muted. Most internal circuitry
is active while muting the output and
turning off the display and controls.
Back Panel Configuration
page 7 © 2002 bel canto design, Ltd. PRe6 User’s Guide rev082102