Bel Canto Design PRe6 - Manual (Page 9)

page 9 © 2002 bel canto design, Ltd. PRe6 User’s Guide rev082102
SAVE CONFIG ?
After you have edited your settings,
you must SAVE your settings by
using the UP or DOWN arrow keys in
the SAVE CONFIG? screen. Or you
can press ENTER at the Configuration
Input screen, which will bring you to
the SAVE CONFIG? screen, then use
the UP/DOWN arrow buttons to select
SAVE YES/NO and then press ENTER.
ERASE CONFIG ?
This will reset your PRe6 to the facto-
ry settings, use the UP/DOWN arrow
buttons to select ERASE YES/NO and
then press ENTER.
CONFIGURATION (of) INPUTS
Define Inputs:
The input definition screen allows
you to set up and assign all available
inputs. Using the RIGHT and LEFT
arrow keys allows you to cycle
through all available inputs.
Available inputs will depend on
Surround Sound modes chosen.
Inputs 1 and 7 can be configured for
multi-channel use, either 5.1 or 7.1,
in addition to Stereo or Disabled.
Surround Sound modes make use of
adjacent inputs on the back panel as
necessary.
For instance: If you set Input 1 to 7.1
Surround, Input 1 now controls
Inputs 1, 2, 3 and 4. When you define
Input as a Surround format, inputs 2,
3 (and 4 if you chose 7.1 surround)
will no longer be available separately
and will be skipped when cycling
through inputs, as they now are
defined as being part of Input 1. On
the back panel of the unit, these
numbered inputs are also labeled
according to their Surround Speaker:
Input 1 - F for Front left and right.
Input 2 - C for center and LFE for sub-
woofer. Input 3 - S for surrounds and
Input 4 - SB for Surround Back. You
will notice that inputs 6-9 follow a
similar format. Green LEDs on the
back panel show which inputs are
selected to aid in cable connection.
Disable:
When cycling through inputs from
both the front panel and remote,
selecting DISABLE deactivates an
input and removes it from the menu.
Edit Input Name:
Input selections can be labeled with
up to 8 characters consisting of
upper and lower case letters, a space
and numbers 0-9. Press ENTER to
edit Input Name. A cursor will
appear. Use the RIGHT and LEFT
arrow buttons to move cursor. Use
the UP and DOWN arrow buttons to
select the letters and numbers of
your choice. Press ENTER again to
exit Edit mode.
Set MAIN Volume:
Each individual input can be adjusted
in .5 dB steps to match levels from
various source components when
selected (factory default is 65). Use