Bel Canto Design PRe6 - Manual (Page 8)

Factory Configuration:
The PRe6 has the following factory
input settings:
Input 1: 5.1 Surround
Input 4, 5 and 6: Stereo
Input 7: 5.1 Surround
Input 10: Stereo
Input 11: Stereo
TAPE: Stereo
Modifying Factory Configuration :
Press the ENTER button on the
remote eight times or press and hold
the ENTER button on the front panel
for two seconds to engage
Configuration Mode.
Configuration Mode allows you to
customize individual inputs/channels.
Navigation is accomplished with the
UP and DOWN and down arrow but-
ton to select menu options, and the
RIGHT and LEFT arrow buttons to
select the input you wish to change
(See pages 10-14). If you are called
away for more than 30 seconds while
in Input Configuration mode, the unit
will exit Input Configuration mode.
Your changes will remain in memory
(but won’t take affect) until either the
unit is shut off (deleting the changes)
or you reenter Input Configuration
mode and finish your adjustments,
then SAVE (see below).
Top Level Menu
The Top Level menu screen has four
options selectable using the right/left
arrow buttons: CONFIGURATION (of)
INPUTS, CONFIGURATION (of) OFF-
SETS, SAVE CONFIG? and ERASE
CONFIG?.
CONFIGURATION (of) INPUTS :
Using the down arrow button, CON-
FIGURATION (of) INPUTS menu
allows you to customize your PRe6 in
the following ways: Define Input
(5.1, 7.1, Stereo, Disable), Name
Input, Set MAIN Volume, Set
SoftMute Vol(ume), Set Zone2
Volume. Press ENTER to edit a given
setting, adjust setting using the UP
and DOWN arrow buttons and press
ENTER again to exit edit mode.
CONFIGURATION (of) OFFSETS :
The CONFIGURATION OFFSETS
menu allows for adjustment of the
Surround Sound speaker levels. The
RIGHT and LEFT arrow buttons allow
you to select either Surround Input.
As you press the down arrow button,
selection options are: Center, LFE-
Sub, Left Surround, Right Surround.
If 7.1 Surround is enabled, Sur Left
Back and Sur Right Back will also be
available. Surround levels can be
adjusted +10 to –20 dB in relation to
the front main speakers. Press
ENTER to edit a given setting, adjust
setting using the UP and DOWN
arrow buttons and press ENTER
again to exit edit mode.
PRe6 Setup and Options
page 8 © 2002 bel canto design, Ltd. PRe6 User’s Guide rev082102