ADS-TEC IPC1100/1200 - Manual (Page 15)

Industrial PCs IPC1100/1200
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
15
4.3 I NSTALLING ADD - ON CARDS
• Switch off the device and all units connected to the PC and disconnect them from
the power supply.
• Unscrew the cover screws using a matching screwdriver and carefully remove the
cover.
Caution:
The cover may be connected to mechanical parts in the device by a grounding wire! Do
not remove the cover with force...
• Reduce electrostatic charge by implementing the appropriate measures (see
above), remove the add-on card from the packaging, place it in the slot and bolt it
to the card mount.
• Each ISA card should be fastened in the matching slot with a clamp to prevent the
card from falling out.
• Reconnect the grounding conductor if it has been removed and replace the cover
while paying attention to the side clips as the case may be.
• Tighten all of the screws on the cover again.
Pos : 19 /D atent ec hni k/I nbetri ebnahme/ Syst emmer kmale/I nbetri ebnahme f ür I PC 1100 @ 0\ mod_1158845850031_681.doc @ 785 @