ADS-TEC IPC1100/1200 - Manual (Page 21)

Industrial PCs IPC1100/1200
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-E
6.3 230V AC
POWER SUPP
An IEC connector is
supply. The provided
P OWER SUPPLY UNIT
• Power consu
• Input voltag
Note:
The device's typica
Pos : 29 /D atent ec hni k/Schnitts tell en/USB-Ansc hlus s/U SB-Ansc hl uss f ür OPC / IPC / C PC / PLC / OTC / ITC VMT / MSD- Seri e @ 0\ mod_1158923823971_681.doc @ 865 @
6.4 USB CONNECTIONS
The USB interfaces a
complies with the U
PIN NUMBER
1
2
3
4
Note:
The USB interfa
You'll find this softw
USB
CONNECTION ON
One USB interface c
cover beneath the d
opening. The plastic
USB interface, since
Pos : 30 /D atent ec hni k/Schnitts tell en/Netz werkansc hlus s RJ 45/Netz wer kansc hluss RJ 45 für O PC / IPC / C PC / PLC / OTC / ITC / VMT-Serie/ LSI 5015 SEW @ 0\ mod_1158924094127_681. doc @ 867 @
Echterdingen
PLY
used as a power
d cable should be used to connect the device.
T TECHNICAL DATA
umption: Max. 60 Watts
ge: 100…240V AC
al power input is listed in the "Technical Details" s
are used for connecting peripherals with USB con
SB 2.0 standard.
SIGNAL NAME
VDC
D -
D+
GND
faces may be locked using the Lock
tware and the documentation on the service CD.
N THE FRONT PANEL
can be accessed from the front. This interface is
display. The cover has a tab on the right-hand s
c cover must properly be replaced and carefully
e otherwise the protection class of IP65 is no long
21
section.
nnection. The interface
USB software tool.
located under a plastic
side, which is used for
closed after using the
ger ensured.