ADS-TEC IPC1100/1200 - Manual (Page 22)

Industrial PCs IPC1100/1200
22
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
6.5 N
ETWORK CONNECTION
(RJ45)
If the drivers required for functioning are installed on the device, the control system may
be integrated in an Ethernet network supporting the 10/100 Mbit standard by using the
Ethernet 10/100BaseT network connector. Specifications of this network topology must be
observed in this case. You can install the drivers required for functioning from the enclosed
service CD, should they not be installed on the device.
PIN NUMBER SIGNAL NAME
1 TX +
2 TX -
3 RX +
4 NC
5 NC
6 RX -
7 NC
8 NC
Pos : 31 /D atent ec hni k/Schnitts tell en/Seriell e Schnitts tell e C OM RS232/Serielle Sc hnitts tell e C OM (RS232) f ür OPC / I PC / C PC / PLC / OTC / ITC / VMT / M SA- Serie @ 1\ mod_1249303286408_681.doc @ 6105 @
6.6 S ERIAL COM INTERFACE (RS232)
The serial interface is used for digital and for analogue data transmission as well. The RS
232 interface can be connected by using a commercially available 9-pin SUB-D cable.
PIN NUMBER SIGNAL NAME
1 DCD
2 RxD
3 TxD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
Note:
This interface is not electrically isolated.
Pos : 32 /D atent ec hni k/Lauf wer ke/Exter ne Lauf werke/ Ext er ne Lauf wer ke für OPC 5112 / 5115 / 5117 / I PC 1100 / CPC / PLC / OTC / ITC / VMT-Serie @ 0\ mod_1158926656205_681. doc @ 880 @