ADS-TEC IPC1100/1200 - Manual (Page 17)

Industrial PCs IPC1100/1200
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
17
IPC1200
Note:
Cable shielding of a data cable has to be connected to the plug connection casing (EMC).
The interfaces have to be enabled in the embedded operating system and the matching
drivers have to be installed to be able to use the interfaces.
Pos : 20 /D atent ec hni k/I nbetri ebnahme/ Kabelmont age/ Kabelmont age für OPC- Seri e / IPC 5100 / 5300 / 5500 / 1100 @ 0\ mod_1158848147709_681.doc @ 797 @
5.2 C ABLE INSTALLATION
The device interfaces and power supply plug are found on the side of the casing. The free
slots and the drives are found in the same place.
Pos : 21 /D atent ec hni k/I nbetri ebnahme/R eihenfolg e der Inbetriebnahme/R ei henf olge der I nbetriebnahme f ür I PC 1100 @ 0\ mod_1158850330926_681.doc @ 801 @
5.3 S
TARTUP PROCEDURE
• For 230 V AC device: Insert the power cable in the IEC connector and connect it
to the power source.
• Connect the cable for serial / parallel data transfer and fasten the plugs to the
sockets.
• Connect all further required cables and secure against slippage.
Pos : 22 /D atent ec hni k/I nbetri ebnahme/ Betriebsberei tschaf t prüf en/ Betriebsbereit schaf t prüf en f ür O PC/C PC/ PLC /OTC /ITC/ VMT-Serie(+Monit ore) / I PC 5100/ 5500/ 2400/1100 @ 0\ mod_1158905578361_681. doc @ 806 @
5.4 C HECK OF READINESS FOR OPERATION
Check the device for any hidden damage caused by improper transport, improper
operating or storage conditions or by improper use (e.g. smoke development from the
device, etc.). Immediately shut down the device and prevent any further accidental
commissioning if any damage is detected.
Pos : 23 /D atent ec hni k/Schnitts tell en/Exter ne Tast at ur/Exter ne Tast atur f ür O PC / CPC / PLC / OTC / ITC / VMT-Serie / I PC 51/ 53/11/ 5500 @ 1\ mod_1242716042480_681.doc @ 5557 @