AIM Sports Green Laser Scopes - Manual (Page 10)

7 28
SCOPE INSTALLATION
YOUR SCOPE IS DESIGNED TO MOUNT TO ANY
WEAVER / MIL STD PICATINNY 1913 RAIL
FOR SCOPES EQUIPPED W/ THUMB SCREWS
(MODELS JSDG15532G-N & JDG251040G-N)
1. Loosen the thumb screws on the mount base, and place it on the rail
where desired. Make sure the scope base is sitting flush on the rail, and
is not canted.
2. Tighten the thumb screws by hand, and check the eye relief on the
scope to ensure that the scope is mounted in the optimal position.
3. Using a standard screwdriver or a coin, complete the final tightening
of the thumb screws to ensure that the scope is secure to the rail. Don’t
overtighten screws. You may use thread locking compound if desired in
order to help avert loosening of the thumb screws due to recoil.
4. Be sure to use factory-loaded ammunition of the same bullet type,
weight, and preferably, lot number. If one type of ammunition does not
shoot well, try another brand or bullet weight.
5. Be certain that both the barrel and chamber are clean. Heavy
factory grease or copper fouling in a barrel can diminish the accuracy of
the firearm.