AIM Sports Green Laser Scopes - Manual (Page 14)

11 24
ADJUSTING LASER
To adjust the windage and elevation on the laser attached to the scope,
note the position of the windage and elevation allen screws located on the
laser (Fig 1). An allen wrench is provided to use to make the necessary
adjustments. The screw on the top of the laser body adjusts elevation, and
the screw located on the side of the laser body controls windage.
1. In order to move the laser up and down (elevation), insert the allen
wrench into the top screw.
2. Turn the screw clockwise to move the laser down.
3. Turn the laser counter clockwise to raise the laser up
4. To adjust the windage to the left, insert the allen wrench into the screw
and turn it counter clockwise.
5. To move the laser to the right, turn the allen wrench clockwise.
FOR SCOPES MODELS JSDG15532G-N & JSDG15532G
1. Make sure the laser is off, and unscrew the battery cap located at the
front of the battery compartment under the laser. You may need
to use a coin or standard screwdriver to loosen the cap.
2. Remove the 3v cr2 battery.
3. Replace with a new battery, positive side facing the battery cap.
4. Screw the battery cap back on, and activate the on/off switch to check
function of laser.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.