AIM Sports Green Laser Scopes - Manual (Page 16)

22
This can be done in two ways:
a. Grasp the edges of the battery between the thumb and forefinger and
lift it free of the dial.
OR
b. Turn the scope so that the illumination dial faces downward and
gently tap the eyepiece against the edge of your palm.
3. Insert the new battery, positive (+) side up.
4. Replace the battery cover on the illumination dial and turn it clockwise
until it is secure while holding the sides of the illumination dial to keep the
entire dial from turning.
Replacement 3-volt lithium batteries:
AIM Sports ........... CR2032
Duracell ................ Dl1/3N
Eveready .............. 2L76
Kodak ................... K58L
Varta ..................... CR1/3N
Sanyo ................... CR1/3N
There may be other lithium batteries that are acceptable with your AIM
Illuminated Reticle scope. Check with your local retailer for other options.
Figure 1 Figure 2
ADJUSTING ELEVATION
1. Unscrew the cap located on elevation dial (located on top of scope) to
expose the elevation adjustment dial. Make sure the BDC dial, if
applicable, is located at #1. (Fig 1)
2. Turn the dial counter clockwise (noted on the dial as up with an arrow
pointing to the left) in order to raise the elevation/point of impact. (Fig 2)
3. Turn the dial clockwise to the right to lower the elevation.
4. Replace the cap to protect the dials from being moved out of alignment.
13