AIM Sports Green Laser Scopes - Manual (Page 15)

23 12
6. If your scope has been zeroed prior to these steps to the desired
distance, you may look through the eyepiece and move the laser to the
point desired relative to the reticle crosshairs.
ADJUSTING WINDAGE AND ELEVATION
The style of elevation and windage adjustments on AIM riflescopes varies
with specific models. Each, however, is clearly marked in easy to read
increments. If, for example, there are four hash marks from zero to (and
including) the number one on an adjustment knob, then the value of each
increment of adjustment on that knob is 1/4-MOA. It is the same with all
AIM adjustment dials. One-MOA moves the point of impact at 100 yards by
1inch. At 100 meters, it moves 25mm.
The letters found on the windage and elevation dials refer to the direction
that the point of impact of the bullet is moved when an adjustment is made.
CHANGING LASER BATTERY
FOR SCOPES MODELS JDG251040G-N, JDG251040G,
AND JDNG251040G
1. Make sure the laser is off, and unscrew switch cap on the laser module.
2. Remove the 3v cr2 battery.
3. Replace with a new battery, positive side facing the switch cap.
4. Screw the switch cap back on, and activate the on/off switch to test.
Figure 1