AirLive Air3GII - Manual (Page 53)

3. Making Configuration
AirLive Air3GII User’s Manual 49
3.4.4. SNMP
In brief, SNMP, the Simple Network Management Protocol, is a protocol designed to
give a user the capability to remotely manage a computer network by polling and setting
terminal values and monitoring network events.
1. Enable SNMP: You must check “Local”, “Remote” or both to enable SNMP function.
If “Local” is checked, this device will response request from LAN. If “Remote” is
checked, this device will response request from WAN.
2. Get Community: The community of GetRequest that this device will respond.
3. Set Community: The community of SetRequest that this device will accept.
4. IP 1, IP 2, IP 3, IP 4: Enter the IP addresses of your SNMP Management PCs. User
has to configure to where this device should send SNMP Trap message.
5. SNMP Version: Select proper SNMP Version that your SNMP Management
software supports.
6. WAN Access IP Address: If you want to limit the remote SNMP access to specific
computer, please enter the PC’s IP address. The default value is 0.0.0.0, and it
means that any internet connected computer can get some information of the device
with SNMP protocol.
Click on “Save” to store your settings or click “Undo” to give up the changes.