Routing – AirLive Air3GII User Manual
Page 54
3. Making Configuration
AirLive Air3GII User’s Manua
l
50
3.4.5. Routing
If you have more than one routers and subnets, you will need to enable routing table to
allow packets to find proper routing path and allow different subnets to communicate
with each other. The routing table allows you to determine which physical interface
address to use for outgoing IP data grams.
1. Dynamic Routing: Routing Information Protocol (RIP) will exchange information
about destinations for computing routes throughout the network. Please select
RIPv2 only if you have different subnet in your network. Otherwise, please select
RIPv1 if you need this protocol.
2. Static Routing: For static routing, you can specify up to 8 routing rules. You can
enter the destination IP address, subnet mask, gateway, and hop for each
routing rule, and then enable or disable the rule by checking or un-checking the
Enable checkbox.
Click on “Save” to store your settings or click “Undo” to give up the changes.