AirLive CoreNVR 9 - Manual (Page 17)

4. System Setting
AirLive CoreNVR 9/16 User’s Manual 11
Auto setting could insert intranet’s cameras , even them behind of several switch hubs ,
or you could just direct insert cameras on NVR’s switch hub , then click “ Auto Setting
“ button to add them into system .
Through “ Auto Setting “ function , you won’t need to key-in any network IP or sub-mask
parameter , you only need to click “ Auto Setting “ button to finish insert IP camera job.
4.1.2 Template Setting
When you use “Auto Setting” or add a new camera, system will read the camera
template from “Template Setting” for fill the camera parameter.
After you confirm the template, in most case, you will no longer need to set camera’s
parameter again.
You could setting the quick template from camera setting page, in most case you only
need set the camera’s resolution and frames per second.
If you need set more detail template, please click the “Advanced” button to approach the
template setting dialog.
Resolution
The new camera will try to fit selected resolution, if you select “Max”, camera will use
maximum resolution, or you could select another resolution, system will choose a
near one resolution of camera.
FPS: Set the frames per second of camera, system will try to set a near or equal FPS
to camera.
Rate Control: Set the rate control algorithm of new camera.
Quality: If you select the EVBR for new cameras, you could set then VBR quality
here.
Account: Setup the default login camera user account.
Password: Setup the default login camera password.