AirLive MFP-101U - Manual (Page 120)

13.2 Enable MFP Server’s TCP/IP Support
The default configuration of the MFP Server is with TCP/IP support enabled.
Anyway, you can configure the MFP Server to enable TCP/IP support using
the configuration program.
13.3 Setup MFP Server’s IP Address
The MFP Server must have a unique IP address in order to be recognized by
the network.
You can set up the IP address on the various Unix systems using any one of
the following methods:
1. DHCP (Dynamic Host Configuration Protocol)
2. BOOTP (Bootstrap Protocol)
The MFP Server will use the last two methods to obtain its IP address
automatically if its IP address is configured as Auto (0.0.0.0).
13.3.1 DHCP
There are many Unix systems that support DHCP protocol, and the
procedures to configure the DHCP server database are different. Please refer
to the manual of Unix for the way to use different DHCP Server. It is highly
recommended that the DHCP server should be located on the same network
as the MFP Server.
113 AirLive WFP-101U User’s Manual