AirLive MFP-101U - Manual (Page 129)

15. Troubleshooting
1. This product is not found even after searching by the “MFP Manager”.
„ Check if the power adapter and the network cable are connected to the
MFP Server properly.
„ Check if the LAN and Ready LEDs are turned on.
„ Check if the IP Address of the MFP Server is in the network segment
as your computer.
- If you are not sure the IP Address setting of the MFP Server, please
check the TCP/IP setting of the MFP Server from the “Server
Manager”.
2. The ways to change the IP Address of the MFP Server.
„ A DHCP Server is installed in the network
If a DHCP Server is installed, you can setup to let the MFP Server get IP
Address from the DHCP Server automatically.
1. Open “Server Manager” and then select “TCP/IP” setting.
2. Select “Auto IP” and click “Save”.
3. Reboot the MFP Server.
„ Set up the IP Address Manually
1. Open “Server Manager” and then select “TCP/IP” setting.
2. Select “Static IP” and enter the IP Address and Subnet Mask as your
computer. Click “Save”.
3. Reboot the MFP Server.
Note: Set a static IP Address to MFP Server is recommended since
DHCP assignment may dramatically change the IP Address for MFP
Server.
122 AirLive WFP-101U User’s Manual