AirLive POE-FSH808PW - Manual (Page 51)

4. Web Management
AirLive POE-FSH808PW User’s Manual
46
 System Priority: This column allows you to enable or disable Loopback Detection
function.
 Link Aggregation Algorithm:
 MAC Src: Hash Algorithm based on Source MAC Address.
 MAC Src&Dst: Hash Algorithm based on Source & Destination MAC Address XOR
result.
 Member: This column allows you to select the member Ports.
 Status: This column allows you to Enable/Disable the Trunk Group.
 Type: This column allows you to choose Static Trunking or Dynamic LACP Trunking.
After Select the LACP Trunk type, the following parameters can be configured. Please
noted that the parameters of the both ends of the LACP should be the same.
 Operation Key: This column allows you to type operation key.
 Time Out: This column allows you to select Long Time Out Time or Short Time Out
Time. The Long Time Out is around 30 seconds, the Short Time Out is around 3
seconds, however, the link partner of other supplier may not use the same value. The
longer time then will be used.
 Activity: This column allows you to select Passive or Active mode.
*Note: If you enable LACP on some specified ports and their link partners are normal port
without LACP, these specified ports cannot transmit packet to/receive packet from the link
partner.