Allen&Heath DR66 USER GUIDE - Manual (Page 31)

DR66 & DR128 Installer User Guide 31
If the current configuration has had only partial
patches recalled or available then the display
indicates this as shown here. ‘00’ and ‘No Patch’
shows that no full patches have been recalled.
However, ‘25’ shows that patch 25 was the last
partial patch recalled.
If the current configuration has only had full patches
recalled or there are no partial patches available
then the display indicates as shown here.
The Function Keys
The 8 DR66 and 12 DR128 front panel function keys may be assigned and operated as follows:
Unused The key has no function. The display
does not change.
Level The function key has been assigned to
select the ▲ and ▼ keys as level up/down controls
for the associated input, output channel or matrix
crosspoint. The LCD displays the level bar for two
seconds after it is pressed before reverting to normal
display. If the ▲ or ▼ key is pressed during that
time then the level is incremented or decremented.
Each full block represents a value of 10, each half
block a value of 5 on the scale of 0 to 100.
The example here shows that the channel named
‘Mic 1’ can have its level adjusted up or down. The
current level is 45.
The level bar corresponds to the following values:
Display 0 5 10 15 20 25 30 35 40 45 50
dB off -39 -35 -32 -29 -26 -23 -20 -17 -15 -13
Display 55 60 65 70 75 80 85 90 95 100
dB -11 -9 -7 -6 -5 -4 -3 -2 -1 0
If the function key has been assigned a minimum
and/or maximum level then the display shows when
the limit is reached by drawing a line across the
arrow head. This example shows that a minimum
assigned level of 20 has been reached. The level
cannot be decremented any further.
00/25 No Patch
Mon 19:03:26
01/00 Daytime
Mon 19:03:26
Mic 1 Lev 45
█ █ █ █ ▌ _ _ _ _ _ ↓↑
Mic 1 Lev 20
█ █ _ _ _ _ _ _ _ _ ↓↑