Altman Lighting Phoenix LED Profile Spot - Manual (Page 5)

Altman Lighting, Inc. 57 Alexander Street., Yonkers, NY 10701 1-800-4-ALTMAN
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT 2012© ALTMAN LIGHTING, INC/ ALL RIGHTS RESERVED
1/24/14 rev:C
5
ACCESSORY INSTRUCTIONS
ACCESSORY RETAINING LATCH
This unique retaining hatch is designed for
positive locking and manual return.
1. Slide cover to right side.
2. Swing cover back.
3. Insert accessory.
4. Close cover. Make sure latch locks in
place.
DROP IN IRIS SLOT
This larger slot can accept either a drop-in iris
or a motorized pattern device (gobo rotator,
yo-yo etc). The slot has a retractable cover to
prevent light leak when not in use. When a
device is used, the cover should be closed to
the edge of the device placed in the slot.
When a drop-in iris is used, always place it so
the flat side is facing the shutters.
PATTERN PROJECTION
The pattern holder accepts standard ETC
Source 4 size pattern holders. The image of
the pattern can be rotated 360° in either
direction. The use of the donut will sharpen the
image.
INSTALLING SHUTTER PLATES
1. Pressure Plate (completely flat): Install
such that the tabs are on the top and
bottom and sides.
2. Iris and spring plate. Install so that the (4)
studs face the back of the unit.
SHUTTERS
1. The shutters are not removable without
dissembling the unit.
2. Care must be given to make sure each of
the four shutters stay in their proper
positions in between the shutter plates.
Plate Stud
Springs
SOFT FOCUS LENS ADAPTER Part #: PHX-SFLA (sold separately)
The soft focus lens adapter is a 5° luminate holographic lensing option to help diffuse the LED
array for a softer focus. The matte side of the diffusion should face the light source as the shiny
side should face the lens barrel. NOTE: Do not add metal gobos in the same pattern holder. The
heat build up will melt the diffusion material.