Altman Lighting Phoenix LED Profile Spot - Manual (Page 7)

Altman Lighting, Inc. 57 Alexander Street., Yonkers, NY 10701 1-800-4-ALTMAN
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT 2012© ALTMAN LIGHTING, INC/ ALL RIGHTS RESERVED
1/24/14 rev:C
7
DMX Control
DMX Address 1 to 512
Menu Category Control Type Option 1 Option 2 Option 3 Factory Default
001
DMX Resolution 8 Bit
16 Bit
8 Bit
Master Channel Off
On
Off
Smoothing Off
On
On
DMX Loss off
Hold Last Look
Preset (cue 1)
Off
DMX Control
-DMX Address (1-512)
-DMX Resolution (8 Bit or 16 Bit)
-Master Channel (Off or On)
-Smoothing (Off or On)
-DMX Loss (Off, Hold Last Command, Preset)
Operation Menu and Options
To address your fixture follow these steps:
1-Power the fixture and wait for the startup to complete. The screen will turn off.
2-Press ENTER and you will see “DMX Control” press ENTER again.
3-When the screen shows “DMXAdr 1” press ENTER again. The up and down arrows should now
be next to address 1. (See image 2 below)
4-Press the UP or DOWN buttons to scroll to your desired DMX address.
5-Press ENTER to confirm the address.
6-Press MENU to back out of the DMX address setting.
The up and
down arrows
must be next to
the number in
order to scroll to
your desired
DMX address.
The table below demonstrates the DMX Control Options you can choose from. By following the
same steps to address your fixture you can choose any of the following options from below.