Bakers Pride FC-816 Manual - Manual (Page 6)

A. MOUNTING LEGS WITH CASTERS:
Legs are shipped in a separate carton complete with mounting hardware and casters, (two of them with
wheel brakes).
NOTE : Installation should be made with a connector that complies with the latest edition of the Standard
for Connectors for Movable Gas Appliances ANSI Z21.69 in the USA (CAN CGA6.16 in Canada) and a
quick disconnect device that complies with the latest edition of the Standard for Quick Disconnect Devices
for use with gas fuel ANSI Z21.41 in the USA (CAN CGA 1-6.9 in Canada) and adequate means must be
provided to limit the movement of the appliance without depending on the connector and any quick
disconnect device or its associated piping. The restraint should be attached to the rear legs of the oven on
which casters are mounted. If disconnection of the restraint is necessary to move the oven for servicing
needs, the restraint should be reconnected after the appliance has been returned to its originally installed
position.
a) Bolt two (2) legs with casters and wheel brakes firmly to the two (2) upper (front) corners of the oven as it
stands on the skid (see Sketch “E”).
b) Using proper lifting equipment, lower the oven down so that the two bolted legs rest on the floor (see
Sketch “F”).
c) Using proper lifting equipment, raise the back side of the oven to a height slightly higher than the height
of the legs, remove the skid and place a sturdy support under the back side (see Sketch “G”). Mount
remaining two (2) legs and tighten bolts. Lift the oven and remove the supports.
d) Move the oven to its final location, keeping the minimum clearances from the back of the oven to the
wall. This clearance is necessary for safe operation and to provide proper air flow to the burner chamber.
Sketch “D” Sketch “D”
$
BAKERS
PRIDE
Vent Hood
(Not Included)