Bakers Pride FC-816 Manual - Manual (Page 8)

&
Sketch “I”
Four
Deck
Wedges
C. Optional Ceramic Top Installation:
5. BOOSTER BURNER INSTALLATION:
NOTE: The Booster Burner and the Booster Burner Guard are shipped inside the burner
compartment and have to be installed before the booster burner can be used for the first time.
6. GASAND ELECTRIC CONNECTIONS:
NOTE: Propane Gas Units are not available in the European Community.
If the oven was ordered with the ceramic top option, the two top supports are already installed. Simply slide
in the ceramic tops as per instructions below. If this option is an add-on, you must follow the instructions
provided with the Ceramic Top Installation kit.
a) Through the arched front opening, insert one of the center slabs (20 13/16 x 20 13/16 for FC616 and
FC816)(17 1/2 x 17 3/4 (left to right) for the FC516) into the bake chamber, raise one side until the other side
comes to rest onto the center support, then lower the first side to lock it in between the two center supports.
Push it to the rear as far as possible to make room for the second center slab.
b) Install the second center slab (20 13/16 x 20 13/16 for FC816)(14 3/16 x 20 13/16 (left to right) for
FC616)(17 1/2 x 17 3/4 (left to right) for FC516) into the bake chamber and push it tightly against the first
slab.
c) Install the side slabs (20 13/16 x 20 13/16 for FC816)(17 1/2 x 17 3/4 (left to right) for FC616)(17 1/2 x 13
3/4 (left to right) for FC516) in a similar fashion, raising the slab in the center until the lower side edge rests
on the side support, then lowering the upper edge onto the center support. First the ones in the rear, then the
ones in the front, pushing them tightly against the first slabs.
a) Once the Pizza Deck Slabs are installed as per instructions above, place the booster burner and guard
inside the bake chamber, as far back as possible, then follow with your upper torso and do the following:
b) Center the guard in front of the booster burner brackets, flange down, wings back, then push it all the way
back and under the booster burner brackets.
c) Reach over the guard, slip the throat of the booster burner over the gas nozzle, then lower it and insert the
two burner ends into the locating slots of the booster burner brackets and push them all the way down.
A) Normal factory connections are made for 120 Volts AC, 60 Hz operation in USA and Canada. For use in
Europe, the connections are made for 230 VoltsAC, 50 Hz operation.
b) The appliance, when installed, must be electrically grounded in accordance with local codes and/or the
latest edition of the National Electric Code /NFPA 70 in USA (Canadian Electric Code CSA C22.2 in
Canada).
c) In Europe, the appliance must be connected by an earthing cable to all other units in the complete
installation and thence to an independent earth connection in compliance with EN 60335-1 and/or local
codes.
ANSL