Xit6000-ca, Setup & assembly instructions – BAND-IT XIT 6000-CA 3/8 Tie-Lok Tool User Manual
Page 11
Document # XIT177 Rev E
© Copyright
BAND-IT-IDEX, Inc. 2005
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
11
XIT6000-CA
3/8” Tie-Lok
®
Tool
Setup &
Assembly
Instructions
Three additional fixture mounting holes are available
to assist with mounting the XIT6000-CA. Thread
size is #10-32 for each of the holes. Usable thread
depth is .400” for two of the three fixture holes. One
hole is utilized to attach and lock the tool body
halves together. This hole may also be used for
fixturing, provided the #10-32 cap screw is replaced
with a similar threaded screw with appropriate
thread length secure the two halves together in
addition to fixturing.
Note: Hole locations
are .750” to
centerline of holes
and edge of tool as
indicated by the
detail to the left.
Fixture Mounting Locations
Fixture Locating Points