BAND-IT XIT 6000-CA 3/8 Tie-Lok Tool - Manual (Page 22)

Document # XIT177 Rev E
© Copyright
BAND-IT-IDEX, Inc. 2005
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
22
XIT6000-CA
3/8” Tie-Lok ® Tool
The XIT6000-CA requires preventative maintenance as indicated below. The “Clamps
Installed” column indicates how many clamps can be installed between each servicing.
Maintenance
Replace gripper Front Gripper 50,000
Replace Assembly Tension Block Assembly 50,000
Clean, re-lubricate, and inspect for
multiple broken teeth
Front Gripper 25,000
Rotate (page 18) Cut-off Blade 25,000
Clean & Re-Lubricate Tool Head 25,000
Clean & Re-Lubricate Flip Cover 12,500
Clean & Re-Lubricate Tension Block Assembly 12,500
Maintenance
Action
Maintenance
Item
Clamps
Installed
Replace Cut Off Blade 50,000
Replace Cut-off Knife Assembly 25,000
Clean & Re-Lubricate Mechanical Linkage 25,000
Preventative Maintenance Schedule
Tool Preventative Maintenance:
The tool has some wear components that must be checked and replaced on a certain
schedule. BAND-IT has developed a Preventative Maintenance (PM) schedule to help
facilitate these requirements. An excerpt from this PM Schedule is shown below. If tools
are experiencing difficulties during function or there audible air leaks coming from inside
the handle, the tool should be returned to BAND-IT-IDEX, Inc. for servicing.