BAND-IT XIT 6000-CA 3/8 Tie-Lok Tool - Manual (Page 28)

Document # XIT177 Rev E
© Copyright
BAND-IT-IDEX, Inc. 2005
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
28
XIT6000-CA
3/8” Tie-Lok ® Tool
Lubrication – Follow recommended intervals – Use a synthetic gel lubricant containing
Teflon for the internal parts as shown and described. Lubricate all pivot points and internal
surfaces of maintenance flip cover with a light coating of the lubricant.
Caution – Excessive amounts of lubricant may result in gripper slippage, requiring a
full repeat of cleaning process.
Maintenance
Tool mechanics
every 25,000 cycles
Lightly lubricate all
points indicated with
red arrows.
Tension Block Assembly
every 12,500 cycles
Note: Ensure no
lubrication is present in
the center of Gripper.
(indicated by the
blue
circle )
Maintenance Flip Cover
every 12,500 cycles
After the Maintenance
Flip Cover is cleaned,
lubricated, installed and
Quick Release Pins are
in place, apply tension
to the Maintenance Flip
Cover Tightening
Screw. Torque to 12-15
inch lbs. Refer to
pages 5, 18.