Xit6000-ca, Maintenance, 3/8” tie-lok – BAND-IT XIT 6000-CA 3/8 Tie-Lok Tool User Manual
Page 25: Tool
Document # XIT177 Rev E
© Copyright
BAND-IT-IDEX, Inc. 2005
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver, CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
25
XIT6000-CA
3/8” Tie-Lok
®
Tool
Tool Punch Height:
The punch can be checked for excessive wear and damage by measuring the height it
extends above the knife surface. To do this follow the directions listed below.
Maintenance
1.
Pinch the line coming from the tension regulator on the controller module and
depress the tool trigger. This will activate the cut-off and extend the knife assembly.
2. Thoroughly clean the punch tip and knife surface so that both are free of debris.
3. Measure the height that the punch sticks out above the surface of the knife.
4. When the punch height drops below .120" (3.18mm), or shows evidence of chipping,
replace the punch and/or knife.
Punch
Knife
Punch Height
.120” min.