Barranca Diamond MK-100 TILE SAW - Manual (Page 20)

20
RE-CIRCULATION
When using the re-circulation method, the water should be changed often for longer pump life.
(A)
Ensure the Drain Plug is in-
stalled in the Water Basin.
MK-100 SETUP
NOTE:
(B)
Place the Water Pump in the
back of the Water Basin.
MK-100 SETUP FOR OPERATION
Before powering or starting, check for damage that could prevent this equipment
from proper operation or performing it's intended function. Check for binding and
alignment of moving parts. Check for damaged, broken, or missing parts.
CAUTION
In order to avoid breaker tripping, a 20 amp circuit breaker should be used.
Voltage 120v
Cycle 60Hz
Phase 1-phase
If using an extension power cord, make sure the length and wire gauge correspond to he
requirements listed in the Table on Page 10. An extension power cord that is too small in wire gauge
(diameter), or too long in length, will cause the motor to overheat and could cause premature failure.
Use an approved Ground Fault Circuit Interrupter (GFCI).
Do not cover the motor vents as this could lead to motor overheating.
NOTE:
Ensure the power cord and cooling tube exit the water basin under the top rail of the frame. NOTE:
Verify the ON/OFF switch is in the OFF position.
Before connecting the MK-100 to a power supply, be sure the voltage, cycle and phase of the job
site power source meet the requirements in the table below.