Barranca Diamond MK-100 TILE SAW - Manual (Page 28)

28
MK-100 MAINTENANCE
MAINTENANCE
Perform the following after initial purchase and operation of the MK-100.
To extend the life of the MK-100, the following procedure should be performed after each use.
Lubricate all points listed below with light oils such as, 3 in 1, WD-40, etc.
Maintenance Following Use
(A)
Lubricate the Guide Bar.
(B)
Lubricate the Roller
Wheel Assembly.
The following maintenance should be performed monthly.
Monthly Maintenance
(A)
Remove the Diamond Blade.
(B)
Clean and lubricate the Outer
Flange and Retaining-nut.
(C)
Lubricate the Arbor Shaft.
(D)
Verify the Roller Wheel
Assembly is tight and in
good condition.
(E)
Verify all motor mounting
Bolts are tight.
(F)
Verify the Motor Adjustment
Strap is tight.