Barranca Diamond MK-100 TILE SAW - Manual (Page 21)

21
MK-100 OPERATION
PORTABLE GENERATOR
GROUND FAULT INTERRUPTER
If using a portable generator to provide power, ensure the generator meets the following minimum
requirements: 8Kw 120 Volts 20 Amps Single Phase
Ground Fault Interrupters (GFCI) provide protection from the dangers of electrical hazards.
Receptacles are available having built-in GFCI protection and may be used for this measure of safety.
Otherwise a GFCI should be used.
(A)
Ensure the ON/OFF Switch is
in the OFF position.
(B)
Plug MK-100 into GFCI.
(C)
Plug the GFCI into
the power source.
SET CUTTING DEPTH
When loosening the Cutting Head Adjusting Knob, the Cutting Head will pivot
down unless held.
If the plug or receptacle does get wet DO NOT plug/unplug the cord.
Disconnect the fuse or circuit breaker that supplies power to the tool.
Then unplug and examine for presence of water in the receptacle.
(A)
Loosen Cutting Head
Knob and move Cutting
Head down.
(B)
Set cutting depth approxi-
mately 1/4 to 1/2 inch below
the surface of the Movable
Cutting Table.
(C)
Ensure the Adjusting
Knob is tight.
CAUTION
WARNING