Online manual not for resale purposes – BLITZ DCII Meters User Manual

Page 7

Advertising

Replay
Press and hold the REC. button down for 4 seconds and the gauges will all replay.
(the green L.E.D will be blinking)While in Replay mode the user can press the MODE
button once to show replay in twice real time speeds. In replay mode the Green
L.E.D. will be flashing. To stop replay mode press the PEAK button once or wait
for replay to end. When multiple meters are connected(daisy-chained) it is possible
to do one touch operation. Also when making them replay/record at the same time.
User will still need to operate the warning/peak display functions seperately since
these functions are not linked.
On the TEMP gauge if the TEMP 2 reaqding is higher than the TEMP 1 it will not
operate correctly.

Contrast display
Hold the MODE button down for 4 seconds, till the Red, Green, and Yellow L.E.D.
appears. Then press the PEAK button to make the display brighter or the REC.
button to make the display darker. Press the Mode button till the Red L.E.D.
disappears. Gauge will be at maximum reading to indicate full brightness and
at its lowest setting for minimun dimness.

Programming/Calibration Instructions for Speed/Power meter
Speed and power readings will not be accurate if the vehicle's speed signal value
and the speed inspection value on the Speed/Power meter do not match. Test drive vehicle
to see if the Speed/Power meter and vehicles speedometer match. If it does not it may
be necessary to calibrate the gauge to the vehicle.
Press and hold down the PEAK button while turning the ignition on. Release after guage
goes through self test mode.
(the green and red L.E.D. lights will blink. Needle will point to 40km/h)
Pushing the PEAK switch will toggle from 40km/h to 80km/h to 2P to
to 4P to 8P and 16P (pulses)
Pushing the REC switch will cause it to toggle backwards from 16P to 40km/h

There is 3 ways to calibrate the meter:
1. If you know the output pulses from the car you can choose from 2P,4P,8P and 16P.
Push the MODE switch to select the setting(gauge will self test then point to zero)
2. Drive the vehicle at a constant 40km/h(25mph) then push MODE button to set.
3. Drive the vehicle at a constant 80km/h(50mph) then push MODE button to set.
We recommend the 80km/h(50mph) calibration for the most accurate results.
Sometimes under varying loads there may be a different reading from the factory
speedometer compared to the Speed/Power Meter this is normal and not a malfunction.
If the variation is a considerable difference then you may need to recalibrate.

Replay function

LED blinking

ＲＥＣ sw.
（３sec）

LED blinking

Push down PEAK with IGN
on

Press PEAK
for up

Push REC
for down

Speed setting

When MODE switch is pushed, Vehicle speed

pulse function ends and Speed calibration starts

Push MODE to set.

Speed calibration

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No part of this may be reproduced,

stored in retrevial systems, or transmitted in any form or means with out prior written permission of Blitz Co., Ltd. (Japan).

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals