Online manual not for resale purposes – BLITZ Scion xB-xA Compressor System User Manual

Page 14

Advertising

19. Remove bolt from the fuel delivery pipe
bracket.

20. Remove the 2 bolts holding down the
fuel rail. NOTE: You need to shift the fuel rail
to install the intake manifold and the
compressor.

*Hint: Reinstall genuine dipstick 180 degrees from

original position (Pointing towards front of
vehicle.) – prior to installing the compressor
and manifold. Refer ahead to #25 instruction.

* WARNING: Be careful when taking fuel rail off,
be sure that the gas pressure is release before
fuel rail is removed. When putting the fuel rail
back, make sure the o-rings are in good condition.
Do not force injectors back into place, this might
cause the o-rings to break and cause a fuel leak.
If the o-rings are difficult to put back use WD-40 or
some type of lubricating fluid to make it easier to
install.

21. Put #18 Intake manifold gasket, install
intake manifold and compressor. Use
genuine intake manifold nut (2),

⑪

Allen bolt

(2), and

⑬

nut (1).

22. Replace fuel rail. Be careful when

tightening down bolts holding fuel rail. Please
refer to factory manual for specs.

23. Using ④ bolt (2), attach to #7 Tensioner
bracket, 2 holes of top of #7 bracket.

24. Once the compressor is attach to the

bracket, tighten and secure everything
down.

*Warning – Make sure to not over-tighten

bolts.

純正ミッション

ドッキングボルト

Bolt

Fuel
delivery
pipe

④Flange bolt

7. Tension bracket
A

⑪Cap bolt

Fuel Rail

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals