Online manual not for resale purposes – BLITZ Scion xB-xA Compressor System User Manual

Page 20

Advertising

加工部分

Part 40. Switch controller and bezel installation.

1. The nut and the washer of the switch
controller are removed.

2. Find a suitable place to mount the switch
controller and switch bezel. As for drilling hole
size, please refer to 2

illustration.

3. Make two holes, one for the switch and one
for the LED. Refer to figure for sizing. After
holes have been made, put switch controller in
and test fit the switch bezel.

4. If everything fits correctly, remove paper
backing and apply bezel into place. Reapply
washer and nut back onto switch controller.
Make sure area is clean so the adhesive will
stick, otherwise clean area before installation.

5. Turn nut clockwise and lock into place. Do
not over tighten. Make sure nut is snug and will
not vibrate loose.

Note: Please turn the adjustment knob to the
“OFF” position. Align the knob to the off position
on the bezel and put it on.

6. Plug in the 5 wire harness plug from the
activation box to the switch controller.

7. Check to see that the plug is securely
attached. Please make sure wiring does not
come is contact with metal or any moving parts.
Wire tie down any excess wires if necessary.
Find a suitable location to mount the activation
box.

8. Run all the wires, except the red wire from
the activation box, to the passenger side glove
box area. (Leave the red wire on the driver’s
side for now.)

Nut &
Washer

39. Switch controller

Nut & washer

40. Switch bezel

39. Switch

40. Switch bezel

39. Switch
controller

23. Harness Plug

40. Plate for switch

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals