BLITZ Throttle Controller - Manual (Page 5)

※ This product is only made for vehicles with 12V DC. Do not install on a 24V DC vehicles or on any
other vehicle that is not a 12V DC.
It can cause a fire or damage(s) to the vehicle.
※The location of the installation is related where the electronic throttle is controlled.
Please be extra careful on the direction and contacting surface while perform the installation.
※If there is a loose connection, the engine will not rev-up properly and the engine check
lamp will light up. On some vehicles, a special equipment will be needed to erase the check lamp.
※Do not perform any installation for a few minutes after removing the key from the ingnition. There are vehicles that the
power does not shut off for over 5 minutes. Moreover, with smart entry systems, place the key far enough where it will
not detect it and perform the installation. There is a possibility that if the key is detected, it will automatically power
ON and the check lamp will come out when the connector is unplugged and it will enter to fail safe mode.
※Be extra careful since on some vehicles, a special equipment will be needed to deactivate the error code.
・Basically do not disconnect the battery while performing the installation. There is a possibility that the “Idle Learning”
time will be needed if the battery is disconnected.
・Be extra careful in the installation process such as the direction of the connectors, contact, etc; since the electronic
throttle controller which is a precision electronic device.
・Symptoms such as sluggish rev and light up of the engine check lamp will occur if the installation is performed
incorrectly. Fully understand the installation process and be extra careful since, as explained above, an engine
diagnosis equipment will be needed to deactivate the error code.
(1) Confirming the location of the accelerator position sensor.
Usually, the accelerator position sensor is located near the base of the accelerator (Gas) pedal.
(Excluding some vehicles). Look closely since usually it is hidden by a cover.
[Attention] Code No. 14671: TRC07C-BF2.
The accelerator position sensor is located at the engine
compartment with the vehicles that are compatible with
this product.
The area circled in white is the sensor. It cannot be installed if the shape of the connector from the
harness that it is included is different. Do not try to force if the shape of the connector is different.
As shown in the picture, it is located near the master back.
It is connected by a wire from the interior of the vehicle to
the sensor at the engine compartment. Connect the BF2 sensor
harness at this location by passing through the service hole and
connect it to the main unit.
- Installation -
Ignoring these indications may cause injuries or minor injuries to the individual and (or) to a third
party. It may also cause malfunctions and breakages to the product and (or) to the vehicle.
ATTENTION
■
Attention on Installation
5