BLITZ Throttle Controller - Manual (Page 7)

To the accelerator
Sensor
To the vehicles’
Harness
Main Unit
POWER
【Connection schematic 1: When +12V is not needed】
Vehicle specific sensor Harness
Controller
(4) Installation of the main unit and controller
・Make sure to plug the 2 pin and 4 pin connectors all the way in.
・Make sure to plug the 10 pin connector from the controller all the way in.
・Bundle together the wiring and attach the main unit where it does not interfere while driving.
(Attach the main unit at a location that does not get highly heated or wet)
Attention! It is very dangerous if the wiring gets into contact with the accelerator.
Be extra careful when installing the wiring.
+12V DC power supply is needed if your Throttle Controller Wiring Harness has one
single RED extra wiring (Approx 95 inches long) comes out. Use the attached splice
to connect to a constant 12V DC or to the IGN-ON 12V DC power supply.
POWER
※ Connect to a constant
12V DC or to the IGN-ON
12V DC power supply.
Do not connect to the ACC.
【Connection schematic 2: When +12V is needed】
To the accelerator
Sensor
To the vehicles’
Harness
Vehicle specific sensor Harness
Main Unit
Controller
Red
7