BLITZ Throttle Controller - Manual (Page 6)

(2) Disconnect the accelerator sensor connector.
Usually, the connector is very hard when disconnecting for the first time. To disconnect,
use a hair dryer to warm and soften it. Do not use hard tool since it will damage the connector.
(3) Installation of the “vehicle specific” sensor harnesss.
Install the connectors, besides the BA1 type , as follows.
Figure 1 Figure 2 Figure 3
Lock
Electrical
Tape
※Be careful on the direction of the face on the rubber connectors. (See figures 1 and 2)
Plug by matching the face with the red “Caution Sticker” from the rubber connector with the face
that has the lock.
※The rubber connector does not have a lock. See the figure 3 and make sure to attach the
connectors by wrapping with electrical tape.
※There is a possibility that the engine check light will light up and cause damage to the sensor
or to the product if the connectors are plugged incorrectly. Make sure that the direction of the
“Caution Sticker” and the lock are correct.
※ Install by first removing the waterproof rubber from the vehicle’s connector coming from the
vehicle. (See figure 1 and 2) The engine check light will light up from bad connection if the
waterproof rubber is not removed.
※Since the BA1 type connector has a special shape, it is difficult to differentiate the direction.
Therefore,
use the red “caution sticker” as a guide with the side that has the lock from the
vehicles’ connector and plug it the same way as explained previously.
※
The locks will not fully lock since the shape of the BA1 connector is special. (See figure 3)
※ The measurement when the BA1 connector is plugged is around 47mm~48mm. (See figure 4)
※Make sure to fix in place by using electrical tape. (See figure 5)
※There is a possibility that the engine check light will light up and cause damage to the sensor or
to the product if the connectors are plugged incorrectly. Make sure that the direction of the
“Caution Sticker” and the lock are correct.
※Plug the pins at the bottom holes from the P1 Connector. (See figure 6)
Figure 1 Figure 2 Figure 3
Figure 4 Figure 5
Waterproof
Rubber
Vehicles’
Connector
47-48mm
Install the BA1 connector as follows.
Figure 6
6