Carter-Hoffmann CH900 - Manual (Page 5)

5
LOCATION
For proper operation and maximum performance, locate the unit in
an ambient air temperature of 70ºF (21ºC).
Avoid placement in areas near exhaust fans or where there are ac-
tive air movements.
For safe operation and maximum performance, locate the unit at
least 2” from any wall or combustible material. Do not crimp power
cord.
Unit must be on a solid level surface.
INSTALLATION and STARTUP
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding wire with a
grounding plug which must be plugged into an outlet that is properly installed
and grounded. In the event of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape wire for the electric current.
WARNING—Improper use of the grounding can result in a risk of elec-
tric shock. Consult a qualified electrician or service agent if the grounding
instructions are not completely understood, or if doubt exists as to whether
the appliance is properly grounded.
If necessary, contact a licensed
electrician to install an appropriate
electrical circuit with correct NEMA
receptacle. See serial tag on cabi-
net.
DO NOT use an extension cord.
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical codes. Failure could
result in personal injury and proper-
ty damage.
Damage to unit due to being
connected to the wrong voltage or
phase is NOT covered by warranty.
INITIAL START-UP
1. Prior to use, thoroughly clean the interior of the unit, per the
instructions in this manual.
2. Plug the power cord of the cabinet into a grounded outlet ac-
cording to the voltage and amperage specified on the serial tag
on the heating module. This can be located on the top right
rear corner of the heating unit.
3. Set POWER switch to the “ON” position.
4. Do not load product into the cabinet. Allow the heat to remove
any residual oils which may adhere to inside metal surfaces. A
slight emission of smoke is common during the first few hours of
operation.
T he ground prong of the power
cord is part of a system designed to
protect you from electric shock in
the event of internal damage.
DO NOT cut off the large round
ground prong or twist a blade to fit
an existing receptacle.
CAUTION:
Electrical Shock Hazard
Unit is not waterproof, to avoid
electrical shock, keep unit and
counter from being submerged in
water. Do not operate if unit has
been in contact with water.
IMPORTANT:
Power cord is 10' long
IMPORTANT:
Not under warranty
WARNING:
Risk of personal injury
WARNING:
Risk of personal injury
To prevent an electrical shock hazard between the
appliance and other appliances or metal parts in close
vicinity, an equalization-bonding stud is provided. An
equalization bonding lead must be connected to this
stud and the other appliances/metal parts to provide
sufficient protection against potential difference. The
terminal is marked with the following symbol:
Model US Electrical Power CE Electrical Power
Watts Voltage Watts Voltage
CH600 3200 240 2750 230
CH750 3200 240 2750 230
CH800 3200 240 2750 230
CH900 4200 240 3700 230
CH1600 6200 240 5500 230
CH1800 6200 240 5500 230
ELECTRICAL
INFORMATION