CiDRA Sonar Process Monitoring System - Manual (Page 25)

20909-01C Rev 04 Page 10-2
10.2.2 Sensor Head Inspections
Verify the absence of the following:
 Loose or damaged latch hardware
 Loose or damaged boot seal clamps
 Damage to enclosure
 Damage to seals
 Loose or damaged access cover (including screws and seals)
 Loose
handles
 Loose or damaged electrical connector or seals at the
connector
 Evidence from the condition of the pipe that a pipe leak under
the Sensor Head might occur before the next inspection
(reference paragraph 7.6).
10.2.3 Cables Inspections
Verify the absence of the following:
 Damaged
cables
 Improperly
installed cables (for example, cable is under tension
or too tight bend radius)
 Loose cable management elements (strain reliefs, clamps, etc.)
10.3 Problems Found During Inspection
If inspections turn up serious problems, remove the sonar process
monitoring system from service until repairs can be made.
.