BT DF60 - Manual (Page 20)

• Press the DEL/REC button and the
display will show:
RECORD OGM?
• Press the YES button and the display shows:
LIFT HANDSET!!
If you are replacing a previously recorded
Outgoing Message (OGM) display shows:
NEW OGM? Press the YES button.
• Lift the handset and speak clearly into it to
record your message.
When you have finished speaking, pause for
one second, then:
• Replace the handset and your message is
played back to you.
Display shows:
RECORD OGM?
• Press the YES button to record your
message again.
• Press the STOP/CLEAR button to return to
standby mode.
Using the answering
machine
17
To play back Outgoing Message (OGM)
To listen to the Outgoing message (OGM)
which you have recorded:
• Press the TAD button and the display will
show:
TAD FUNCTION
• Press the ᮣ / II button and the display will
show: MESSAGE EMPTY , Followed by:
PLAYBACK OGM?
• Press the YES button to listen to your
Outgoing message.
• Press the STOP/CLEAR button to return to
standby mode.
If incoming messages have been previously
recorded your DF60 will display:
MESSAGE 01 .
Fast forward to the end of the messages using the
ᮣᮣ button, display shows: PLAYBACK OGM?
The amount of recording time allowed for an
outgoing message is the the same as that allowed
for a memo. (See ‘to limit your memo recording
time’, page 21).
If you don’t lift the handset and record a message
within 7 secs the display reverts back to TAD
FUNCTION
. You must now repeat the last 2 steps.