COATS ProGuard Leverless Plus Tire Changer - Manual (Page 18)

Operation Manual - COATS PRO GUARD PLUS - 18
- Press pedal M and the lift P should raise; to lower the lift, lift the same
pedal upwards.
- Press pedal L on L2 and the spindle fl ange R should turn clockwise.
Press the pedal L on L1 and the spindle fl ange R should turn anti-clockwise.
NOTE: If the fl ange should turn in the opposite direction to that indicated, you need to invert two wires on the plug, if
it is three-phase.
- Turn selector A to the right to lock the movement of the bead loosening carriage; in this situation, the carriage will
only move in work mode (over stroke) by pressing button G, at the back of the control panel.
If the selector is turned to the left (unlocked), it will be possible to only move bead loosening carriage right - left, using
buttons C and D.
- Press button E and the bead loosenig carriage will move upwards; press button F and the carriage will lower.
- Press button B and turn the bead loosening carriage Q, the latter will move out from the work position. Release the
button and the hook will lock again. To move the carriage to the work position, turn the latter towards the machine and
make sure the hook locks it.
- To turn the bead loosening disc, move handle U towards handle T and simultaneously accompany the disc support
by hand downwards or upwards.
- With the pedal I right down, the vertical arm V moves to the work position; with pedal I raised, the arm V tilts back-
wards out of the work position.
- Press pedal N to start infl ating the tire; if you wish to defl ate the tire, use button H at the side of the gauge.
11.0_OPERATIONAL TEST
All the procedures are to be performed without using a tire, making sure that no
other parts of the machine interfere with the movements when performing them.
A
C
E
F
D
B
G
R
P
Q
S
S
T
U
V
L
I
M
N
L1
L2
CAUTION
H