COATS ProGuard Leverless Plus Tire Changer - Manual (Page 37)

Operation Manual - COATS PRO GUARD PLUS - 37
22.0_RE-POSITIONING
To re-position the tire changer in a new workplace, you need to secure the moving parts (i.e. bead pressering
arm etc.) disconnect all the power sources and install it again following all the instructions given in chapter
10.0 “INSTALLATION” of this manual.
Connections to power sources and connections and inspections of the safety systems must be
carried out by trained personnel.
23.0_STORAGE
If the tire changer is to be stored away for extended periods of time, you need to:
- Disconnect the power sources
- Empty the tanks containing operational fl uids
- Protect parts that could be damaged if dust should settle on them
- Grease parts that could damage if they should dry up
When re-commissioning the tire changer:
- Follow the instructions given in chapter 10.0 of this manual
- Replace any damaged parts, referring to the spare parts list. This is to be done by factory authorized service
partners
24.0_SCRAPPING
If you should decide that the tire changer can no longer be used, you are recommended to make it unusable
by removing the power supply connections, emptying the tanks and disposing of the fl uids pursuant to current
state and federal regulation.
The tire changer is considered as heterogeneous waste and must consequently be split-up into parts made of
similar material (electrical parts, plastic parts and ferrous parts), which must be disposed of properly, according
to current State and Federal regulation.
25.0 MAINTENANCE
25.1_General warnings
Non routine maintenance must be carried out by factory authorized service partners
• Routine maintenance, following the relevant instructions, is of crucial importance to ensure the correct operation and
lasting life of the tire changer.
• If routine maintenance is not carried out regularly, the effi cient operation and reliability of the machine could be com-
promised.
Before you start any maintenance job, disconnect the electrical power supply by unplugging the machine
from the mains and disconnect it also from the pneumatic supply by shutting off the valve.
Furthermore, to release the compressed air from the circuit, press the infl ation pedal down for a few secon-
ds.
Defective parts should be exclusively replaced with genuine spare parts by factory authorized service partners.
Removal or tampering with the safety devices (max.pressure valve – pressure regulator) represents a breach
of State and federal OSHA regulations and workplace codes.
WARNING