Det-Tronics X2200 UV Flame Detector with HART - Manual (Page 18)

95-8638 1.1 16
conFigurAtion menu
1) consecutive uv oi Fails Allowable number of consecutive UV Oi failures to produce a fault. Factory set to 3
(minutes). This is the time between fault occurrence and annunciation.
2) time delay Time Delay before alarm is indicated (0 to 15 seconds). Factory default is 0 seconds.
important: In addition to lengthening the time period between the outbreak of a fire and
the fire alarm, a time delay can also affect sensitivity. Consult the factory for guidance
before setting a time delay over 5 seconds.
note: FM Approval covers the detector's performance with 0 (zero) time delay only.
cALiBrAtion menu
1) Loop test This test allows the operator to manually set the analog signal output to a fixed user
defined value. (Range: 0-20 mA).
2) d/A trim This function allows adjustment of the 4-20 mA span factor.
3) calibrate oi This procedure calibrates the Oi test signal for the UV sensor.
1. Bypass/disable all Alarm outputs connected to the detector.
2. Thoroughly clean the sensor and Oi reflector for the UV sensor.
Check the Oi source openings for contaminants and clean as needed.
3. Cover the detector with the provided cover.
4. Initiate Oi Calibration. The detector performs the calibration automatically and
notifies the operator upon completion. The procedure takes approximately two
minutes.
5. Upon completion of Oi calibration, remove the cover and return all alarm outputs
to service.
Configuration Menu
1) Consecutive UV Oi Fails
2) Time Delay
Device Setup Menu
1) Configuration Menu
2) Calibration Menu
3) Write Protect
4) HART Setup
5) Set Real Time Clock
X2200 Root Menu
1) Fire (Yes/No)
2) Fault (Yes/No)
3) Device Info Menu
4) Command Menu
5) Device Setup Menu
Calibration Menu
1) Loop Test
2) D/A Trim
3) Calibrate Oi
Device Setup Menu
1) Configuration Menu
2) Calibration Menu
3) Write Protect
4) HART Setup
5) Set Real Time Clock
X2200 Root Menu
1) Fire (Yes/No)
2) Fault (Yes/No)
3) Device Info Menu
4) Command Menu
5) Device Setup Menu