Det-Tronics X2200 UV Flame Detector with HART - Manual (Page 19)

95-8638 1.1 17
write Protect
This function enables the operator to enable/disable password and write protection capability, as well as to enter
or change a password. The device is provided from the factory with Write Protect off. With Write Protect on, the
use of a password is required to enable writing to the device.
1) set Password The password is used to validate the command to enable or disable writes in the
device. (The factory default password is: 1*******. Once the password has been
changed, the default password is no longer valid.)
To change the password:
1. Select "Set Password" and enter the password. Hit "Send".
2. If enabled, disable Write Protect . Hit "Send".
3. Select "Set Password" and enter NEW password. DO NOT Hit "Send" yet.
4. From within "Set Write Protect" menu, select "Change Password". Hit "Send".
CaUtIon
Always record the new password. If the password is forgotten, the device must be
returned to the factory for re-programming.
2) set write Protect With Write Protect enabled, variables cannot be written to the device and commands
that cause actions to be performed in the device cannot occur.
3) write Protect (Y/n) This indicates whether or not Write Protect is enabled.
Write Protect
1) Set Password
2) Set Write Protect
3) Write Protect (Y/N)
Device Setup Menu
1) Configuration Menu
2) Calibration Menu
3) Write Protect
4) HART Setup
5) Set Real Time Clock
X2200 Root Menu
1) Fire (Yes/No)
2) Fault (Yes/No)
3) Device Info Menu
4) Command Menu
5) Device Setup Menu