ECOXGEAR IR2500: Innovator III User Manual

Page 16

Advertising
background image

16

Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or WiFi

Protected Access (WPA or WPA2). You therefore need to enter the correct WEP or WPA password on
your INNOVATOR III radio to communicate with your network.

Please note that the INNOVATOR III

does not currently support WPA2 Business.

Only the person who set up the network in the first place knows this password; if that person is not you
then you need to find out the password. You can do this by checking with the Customer Service of your
internet provider or the manufacturer of your wireless router.

After approximately 3 seconds, the display goes into the password entry mode:


< END A BCDEF>

To enter the password, use the SCROLL to select each letter/number/symbol of the password in turn.
When the 1

st

letter or number of your password is in the center of the display, press the large dial inward

to select that letter or number. Repeat this process for each letter or number in your password.

NOTE: WEP and WPA passwords are upper and lower case sensitive and MUST be entered exactly

HINT: Use the ’Back’ button to erase incorrect characters that you may have entered. IF the display
shows: “Invalid key” or “Network Error”, an incorrect password has been entered.

After entering the final letter/number/symbol, scroll to find and select END . The word ‘END’ is in the
center of the display press the large dial inwards.

Once the password is entered correctly, your INNOVATOR III should now be able to connect to the
network.

Your radio should now be able to connect to the selected network without having to re-enter a password.
Your password will be saved in your Grace radio even if a power outage occurs. You will have to alter
your password however, should you attempt to connect to an alternative wireless network or you change
your Wi-Fi router.

NOTE: IF you would like to give your radio a static IP address then please see the ‘Network config’
section under the ‘Setting’ section.

Advertising