ECOXGEAR IRCA700: Primo - Manual (Page 16)

16
Steps to connect your radio to your Wireless Network
Getting Started
Step 1 - Power up the radio
(use these instructions if the Quick Start guide at the
beginning of this manual did not suffice).
To power your radio connect the AC Power on the back of your Grace Digital Primo Radio to a wall
power outlet. The radio can be switched between ‘on’ and standby with the power button on the radio.
Once powered on, the display on the front of the radio will light up and show the Grace Digital Audio
splash screen followed by ‘Starting’, ‘Scanning’ and then A ‘Select network’ message with a list of the
available wireless networks should appear underneath this heading.
If the radio does not find a wireless network router, the display will show ‘No networks found’:
If this happens after subsequent attempts you should setup your wireless access point working - see the
instructions supplied with your wireless network.