Elkhart Brass HEROPipe System Manual User Manual

Page 7

Advertising
background image

7

F. Nozzle

The 6000-700E is the nozzle recommended for use with the
Sidewinder™ EXM monitor. It has a range of manually
selectable flow rates and a flush setting. The nozzles provide a
constant flow in each of the flow settings. The stream pattern
adjustment is electronically actuated and controlled using the
monitor controller(s). This nozzle is rated at 80 psi nozzle
discharge pressure when operating with The HEROPipe
System.*Elkhart smooth bore nozzles may also be used.

6000-700E: 250, 350, 500, & 700 GPM

G. Handheld Controller with Docking Station

A sealed handheld remote contains all the controls necessary
for operation of the monitor, oscillation, and nozzle. The
handheld wireless remote allows the operator to control the
monitor from a significantly improved point of vantage, and
allows the team to be distanced and shielded from the extreme
conditions on the floor above. Separate push buttons are
provided for up, down, left, right, fog and straight stream, and
oscillation. The handheld remote, through the use of frequency
hopping techniques, allow multiple transmitters to operate on a
common site without interference (multiple monitors to operate
at the same incident at the same time). The remote also has an
automatic power down feature that will shut down the power
within 15 minutes of no activity, while the monitor continues
to function. As an additional power saving feature, the radio
signal is only transmitted while a button is pushed. The
handheld remote case has a NEMA 4 rating.

Caution: Any modification to the enclosure of the handheld controller will destroy the NEMA 4

rating to that piece of equipment and will void any warranty coverage.

H. Battery

The battery pack is a 12.8V, 13.2 Ah Li-Ion rechargeable
battery. It can be charged from any DC power source 16.0V –
18.0V (>60W). It can also be charged and discharged at the
same time. The built in smart charging system provides a
constant current and constant voltage while charging or
discharging, with a MAX charge rate of 3.0A and a MAX
discharge rate of 26.0A.

The smart charger status LEDs will show the current battery
power and discharge status when the button is pressed.

Notice: In the event that the battery stops functioning during operation, applying the smart

charger to the battery input jack will reset the fault and re-enable it.

Figure 9: 81686001 Handheld

Controller with Docking Station

Figure 8:

SIDEWINDER™

EXM Nozzle

(P/N: 06000701)

Figure 10: 81675000 Battery Pack

Advertising