Elkhart Brass UBEC 1C Valve Controller - Manual (Page 13)

13
3. Press the CLOSE button to move the cursor to the next digit. All LEDs will be off. Press the OPEN
button one time again, one green LED on.
4. After 3 seconds all LEDs will turn on.
5. Press the PRESET button and hold for 5 seconds to transfer the information.
Transfer Information from E3F or E5F to UBEC1C (412)
1. Use the OPEN button to set the first digit of the code 4120, four green LEDs on. Each time the OPEN
button is pressed the next LED will illuminate.
2. Press the CLOSE button to move the cursor to the next digit. Now all LEDs will be off and ready for
the second digit to be entered. Press the OPEN button once, one green LED on.
3. Press the CLOSE button to move the cursor to the next digit. All LEDs will be off. Press the OPEN
button twice, two green LEDs on.
4. After 3 seconds all LEDs will turn on.
5. Press the PRESET button and hold for 5 seconds to transfer the information