ElmoMC Gold Line Digital Servo Drives-Gold DC Bell - Manual (Page 21)

Gold DC Bell Installation Guide
MAN-G-DCBELIG-EC (Ver. 1.200)
||Basic Recommendations| www.elmomc.com
21
Table of Contents
6.1.2. Feedback Cable Port A and Port B Connector
1. On the motor side connections, ground the shield to the motor chassis.
2. At least One COMRET (Common Return) must be connected to the PE.
Implement the following steps to connect the COMRET to the PE:
a.
At the drive, connect the feedback drain wire to one of the COMRET terminals in the
Molex feedback connector (Figure 5.
b. At the motor, connect the feedback cable drain wire to the GND motor chassis
terminal of the feedback connector (Figure 6).
The drawing displays two earth connections.
Figure 6: Feedback Port A and B Cable Assemblies